Here you go. If the pictures don't work. let me know and I'll try
something else.
Dave and Daisy
Begin forwarded message:
> From: David Schweninger <quenty@ntelos.net>
> Date: July 30, 2008 5:21:16 PM EDT
> To: Al Fuller <al@bighealey.org>, Healey Mail List <healeys@autox.team.net
> >
> Cc: David Schweninger <quenty@ntelos.net>
> Subject: Tricarb Choke Cables
>
> Al,
> These pictures show the choke cable setup on my BN7. The main cable
> from the dash is a standard repro.
> I made the cables to the carbs.
> They are all standard motorcycle throttle parts. This consists of
> the Black Sleeving, the End Caps for the sleeving, the 1/16"
> stranded (7X19) Cable, and the Ferrel which is soldered on to the
> upper end of the cable.
> An older motorcycle shop will have all the parts. The newer shops
> tend to be like Kmart ,with complete assemblies in little plastic
> bags.
>
> Good luck
>
> Dave and Daisy
>
>
>
>
>
>
>
>
> This shows the sleeving pulled back. Note the end cap. Also the
> ferrel is just visible on the brass barrel.
>
>
>
> This shows the Ferrel which has a small cup on the large end. the
> cable is pushed through and the cable is splayed open a bit, then
> pulled back in to the cup and soldered.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|