Guys
Does anyone have a bulkhead shot of a rhd healey, hopefully a bj8. I am after
the routing for the extra wiring loom cable that feeds the floor mounted dip
switch. I have seen different routings:
1) plug into the bullets at the bulkhead grommet and travel external across
the insulation panel dropping thru the hole just above the starter solenoid
or
2) again plug into the bullets at the bulkhead grommet and then travel back
thru the grommet to route internal next to the smiths heater.
Also is the largest flattish cable clip still in the same position (as a lhd
car) on the main loom now its not holding the main loom and dip switch cable,
or does it swap position with the clip near the regulator to now hold both.
many thanks Andy
_________________________________________________________________
Win a voice over part with Kung Fu Panda & Live Search and 100s of Kung
Fu Panda prizes to win with Live Search
http://clk.atdmt.com/UKM/go/107571439/direct/01/
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|