healeys
[Top] [All Lists]

Re: [Healeys] Fender Refitting Question

To: "Mark LaPierre" <lapierrem@sbcglobal.net>, <healeys@Autox.Team.Net>
Subject: Re: [Healeys] Fender Refitting Question
From: "Rich C" <richchrysler@quickclic.net>
Date: Sun, 3 Aug 2008 10:11:18 -0400
The tapped steel plate is about 1" x 3" and therefore will pull the inner 
flange tightly closed against the body, spreading the load evenly and 
keeping the flange flat. This is a critical and more difficult area to 
obtain a nice closed seam, and the plate will allow that to happen.

Rich Chrysler

----- Original Message ----- 
From: "Mark LaPierre" <lapierrem@sbcglobal.net>
To: <healeys@Autox.Team.Net>
Sent: Saturday, August 02, 2008 10:59 PM
Subject: [Healeys] Fender Refitting Question


>I am installing my fenders for an alignment check before painting.   Why is
> there a tapped plate used at the top of each rear fender rather than a 
> j-clip
> and screw
> like the other holes.     My original tapped plate was extremely corroded 
> and
> I really don't see a serious need to use a plate as opposed to a j-clip 
> and
> screw
> or even a screw and nut.
>
> What was the reason for these tapped plates?
>
> Mark
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>