Hello Folks,
Sorry I made a gross error. I have a right hand drive car not a left hand
as previously posted. I was so concentrating on not making a mistake I made
one anyway. I'm a moron.
At any rate all the replies have been helpful anyway. I have a lot to
learn.
Below is the original post with the error fixed:
Hello Folks,
I am running new brakes lines in a car I didn't take apart. It is a 3000
built in 2/1967, right hand drive. I have a kit from Automec that has all the
lines. As far as I can tell from the parts manual there are two junctions in
the engine bay. Is that correct? It looks like from the master cylinder a
line
goes to a 3 way where there is an in and out and also the brake switch. From
there it looks like it goes to a 4 way where the 3 lines out go to the 2
front
brakes and a line to the rear. If this is correct where do the 2 junctions
bolt to the car?
Also where does the reservoir mount? Is there a bracket for it?
Many Thanks
Wes Keyes
York, Maine
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|