Hello,
In a quest to ream the bushings for the king pin kit I visited about 15
shops without success. They all say they can do it, but without the proper
reamer they will never be able to ream the 2 bushings so they are properly
aligned.
I thought of sending it to UK or US to get it done, but I think it's waste
of postage money..
I think I finally found a shop which might be able to do the reamer. I am
concerned though with the size of the reamers - what should they be?
I found somewhere, that the sizes should be:
Large 0.688" = 17.4752mm
Small 0.817" = 20.6248mm
(These are the reamer sizes, not the king pin sizes)
Can anyone confirm this?
Many thanks,
Tadek
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|