Hello Mitch; In September of 2001, Steve Byers provided the email
below. Hope that helps.
--Scott Morris; Simcoe, Ontario, Canada
From:
"Steve Byers" <byers@cconnect.net>
To:
Healeys@autox.team.net, ggilliam@usol.com
Subject:
Re: Metal
Date:
Sat, 22 Sep 2001 11:23:31 -0400
Hi, Gordy - I measured the frame rail thickness in several places as 0.075" (
14 gauge).
The door skin, bonnet, and rear wing sheet metal measured about 0.040" - 0.044"
(19 gauge), depending on the location measured. Measurements were taken on sp
ares
that I have in areas without paint.
--Steve Byers Havelock, NC USA
----- Original Message --------------------------------------------------------
------------------------------------------------------------------
From: "Gordon Gilliam" <ggilliam@usol.com>
To: <Healeys@autox.team.net>
Sent: Friday, September 21, 2001 3:12 PM
Subject: FW: Metal
Healeyites, Would one of you out there tell me what the equivalent US metal g
auge of
the body panels and frame pieces is?
Thanks, --Gordy
--- On Thu, 5/15/08, caddi5@comcast.net <caddi5@comcast.net> wrote:
From: caddi5@comcast.net <caddi5@comcast.net>
Subject: [Healeys] sheet metal
To: Healeys@autox.team.net
Received: Thursday, May 15, 2008, 7:43 AM
hello list,
does anyone know the correct thickness,type metal to use in the repair of
fenders,shroud,and frame? thanks in advance Mitch 59 bn4
_________________________________________________________________
Instant message from any web browser! Try the new Yahoo! Canada
Messenger for the Web BETA
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|