Gentlemen;
I am replacing the foam in my seat cushions (not
backs) and have some questions.
1. One of my seats has a solid bottom (no we are not talking about FIA
President's here) and the other a square cut-out through which the
foam can be seen. I have cut the Nock seat softening holes in the
foam (it still looks like the nest that the mouse family made) and
these can be seen through the hole. Which is the correct design for a
BT7 Mk2?
2. The new seat runners that I bought are chrome, is this correct?
3. The nuts holding the seat runners in place (from underneath the
car) have been changed for the correct stepped nuts. These fit
properly through the asbestos heat shield. Question: what was used on
the non-asbestos positions (9 of the 12 positions)? The stepped nut
can be used reversed, it seems unlikely that tight old BMC would use
stepped bolts instead of something cheaper, but you never know.
All and any advice welcome,
Mike
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|