Hello Michael;
About 6 years ago, I downloaded a chassis frame picture off Larry Varley's
website * that was a tiff file of an original blueprint from the Donald Healey
Motor Co. At that time I did a fair bit of cleaning-up and enhancement for
clarification purposes.
Recently I acquired a used frame for my MkI BN7 project and took another look
at the blueprint and expanded a little on what I had done a number of years
ago. The original file is very large and contains quite small detail in it.
The attached doc file is large [3.3Meg] but has good detail when you zoom on
it. I saved it as well in a pdf format and found that, while considerably
smaller in size, the detail is not nearly as clear. I also have the jpeg and
tiff files if you would prefer those.
Hope this will help you with your hole drilling.
--Scott Morris; Simcoe, Ontario, Canada; '60 MkI BN7 & '62 MkII BT7
* Larry Varley's website is fantastic and you will spend hours exploring it.
Check it out at : http://www.acmefluid.com.au/larry/index.html
Michael Giroux <MGIROUX@SGL.COM> wrote: << Hi, Can anyone direct me to a
diagram or photos that will show me where to drill the holes in my new BT7
frame for the brake , fuel , wire harness and exhaust system mounting brackets
and what I call hairpins. Any info on hole sizes would also be helpful.
Michael Giroux 1962 BT7 >>
J. Scott Morris - Keep Smiling, Murphy Lives
---------------------------------
Looking for the perfect gift? Give the gift of Flickr!
[demime 1.01d removed an attachment of type application/msword which had a name
of Chassis Design-amended b.doc]
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|