G'day Mike
My understanding is that it should go together without a problem. However
best to check with experts like Norman Nock to make sure, especially if it's
compatible with the BN2's mechanical levering system.
Mine's hydraulic and nothing like a standard Austin-Healey at all.
Hoo Roo
Patrick Quinn
Sydney, Australia
-----Original Message-----
From: rrengineer@dslextreme.com [mailto:rrengineer@dslextreme.com]
Sent: Saturday, 19 January 2008 4:18 PM
To: Patrick and Caroline Quinn
Cc: rrengineer@dslextreme.com; healeys@autox.team.net
Subject: RE: [Healeys] BJ8 Clutch Swap
I was told that you could bolt up a BJ8 flywheel and clutch to a BN2
because the bell housing is large enough. You would have a faster revving
engine due the lighter flywheel and better shifting because of the BJ8
clutch. Right now I have a complete BN2 clutch and flywheel. Just
weighing my options before I put the drivetrain together.
Mike MacLean
56 BN2
60 AN5
Patrick and Caroline Quinn
> G'day
>
> No it's not. The engine in my car is one of the first C-series 6-cylinders
> built for Wolseley in 1954 and as far as I know still has its original
> flywheel.
>
> It definitely is not a BJ8 flywheel.
>
> Hoo Roo
>
> Patrick Quinn
>
> -----Original Message-----
> From: rrengineer@dslextreme.com [mailto:rrengineer@dslextreme.com]
> Sent: Saturday, 19 January 2008 4:06 PM
> To: Patrick and Caroline Quinn
> Cc: rrengineer@dslextreme.com; healeys@autox.team.net
> Subject: RE: [Healeys] BJ8 Clutch Swap
>
> Patrick,
> Would that be with a BJ8 flywheel?
> Mike
>
>
> Patrick and Caroline Quinn
>> G'day Mike
>>
>> I have a BJ8 clutch complete in the BN3. It's a 100S gearbox (almost the
>> same as a BN2) bolted through a special bellhousing. All you have to do
>> is
>> make sure that you use both the BJ8 driven plate and pressure plate.
>> Bolted
>> straight on to the flywheel too.
>>
>> Hoo Roo
>>
>> Patrick Quinn
>> Sydney, Australia
>>
>> -----Original Message-----
>> From: healeys-bounces+p_cquinn=tpg.com.au@autox.team.net
>> [mailto:healeys-bounces+p_cquinn=tpg.com.au@autox.team.net] On Behalf Of
>> rrengineer@dslextreme.com
>> Sent: Saturday, 19 January 2008 12:46 PM
>> To: healeys@autox.team.net
>> Subject: [Healeys] BJ8 Clutch Swap
>>
>> I have heard you can use a BJ8 clutch in a BN2 transmission. Anyone
>> done
>> this conversion? What would be the benefit?
>> Mike MacLean
>> 56 BN2
>> 60 AN5
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|