Jack: I don't have a picture to send but I can tell you that there should
be two flaps sewn to the tonneau. They would be located on top of the
tonneau sewn along their back edge only. They would be located
approximately over the center of the seats but would more precisely be
located so that they just reach the Tenax fasteneers that you fitted to the
heelboard. These flaps would have the 'other part' of the Tenax.
(The Other) Len
Vacaville, California, USA
1967 3000 MKIII, HBJ8L39031
----- Original Message -----
From: "Jaap Aeckerlin" <j.aeckerlin@gmail.com>
To: "Healey forum" <healeys@autox.team.net>
Sent: Thursday, January 17, 2008 1:04 PM
Subject: [Healeys] BJ8 Tonneau cover
> The latter is giving me some problems and I wonder whether there are any
> listers who can help me with picture(s) of the tonneau cover fitted to the
> car, and especially with the tonneau cover fitted but leaving the two
> front
> seats in use. I expect that the unused part of the cover is folded down
> over
> the support rail and then held down with Tenax fasteners.
> I fitted four Tenax pins on the heelboard but fail to see where the other
> part of the Tenax, on the cover, is fitted.
> Jack Aeckerlin, The Netherlands
> 1964 BJ8 29432
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as thehartnetts@earthlink.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|