Paul & Ken
If you are using silicon as brake fluid, any tight fitting rubber washer
would do. My reservoir had steal holding down rubber on the inside and
aluminum on the outside.
Dan
-----Original Message-----
From: healeys-bounces+dan=warner-associates.com@autox.team.net
[mailto:healeys-bounces+dan=warner-associates.com@autox.team.net] On Behalf
Of PG
Sent: Thursday, December 20, 2007 10:12 AM
To: 'Freese, Ken'; healeys@autox.team.net
Subject: Re: [Healeys] 3000 brake fluid resevoir
I did mine with a deep socket.
However, be warned, each side of the "nipple" has a rubber gasket that stops
the leaking.....you will destroy this gasket when you take the "nipple" off.
They must be replaced with a brake fluid resistant material. I made mine
with some old tire tube....but took me a few times to get it right.
Paul
-----Original Message-----
From: healeys-bounces+bj8mk3=shaw.ca@autox.team.net
[mailto:healeys-bounces+bj8mk3=shaw.ca@autox.team.net] On Behalf Of Freese,
Ken
Sent: Thursday, December 20, 2007 7:22 AM
To: healeys@autox.team.net
Subject: [Healeys] 3000 brake fluid resevoir
Any tips on taking the nipples out of the can so that I can clean and
repaint? The nipple in the center tube is turning and I don't have
sockets that fit down the tube.
Ken Freese
65 BJ8
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|