Hi All -
Got the head off my wonky A90 and found out that one of the push rods is
bent. I was thinking the noise was a spun bearing but now I wonder if it's
just that the PO put in a bonze valve guide recently. I can't think of
anything else that would cause a bent push rod. Ideas / thoughts?
Where can I get decent valve guides?
I also want to pull the caps off the crank bearings - any easy suggestions
for doing this? They are a slight interference fit on the block so you can
pull them off by hand, unfortuantely.
Also, where can I get decent bearings and thrust washers for the motor?
Thanks!
Alan
'52 A90
'53 BN1
'64 BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|