healeys
[Top] [All Lists]

Re: [Healeys] Aluminum cockpit moulding - BT7

To: "Ronald J. Ray" <ronald-ray@sbcglobal.net>, <Warthodson@aol.com>,
Subject: Re: [Healeys] Aluminum cockpit moulding - BT7
From: "Quinn, Patrick" <Patrick.Quinn@det.nsw.edu.au>
Date: Wed, 12 Dec 2007 09:05:59 +1100
G'day

Sorry I can't provide the definitive answer about the moulding fasteners
but I do have a question that someone may care to enlighten me on.

Living in Australia where in most areas it's open top motoring 356 days
of the year I am completely unfamiliar with what is meant by an ice
storm.

Can someone please tell me what happens? What causes it? What do you do?


I recall seeing a film some years back with Sigourney Weaver (Sigh!)
that was set in an ice storm, but no doubt it was all done with mirrors.

Hoo Roo

Patrick Quinn
Sydney, Australia

-----Original Message-----
From: healeys-bounces+patrick.quinn=det.nsw.edu.au@autox.team.net
[mailto:healeys-bounces+patrick.quinn=det.nsw.edu.au@autox.team.net] On
Behalf Of Ronald J. Ray
Sent: Wednesday, 12 December 2007 2:41 AM
To: Warthodson@aol.com; linwoodrose@mac.com; healeys@autox.team.net
Subject: Re: [Healeys] Aluminum cockpit moulding - BT7

Gary,

While the BMC parts book does not specifically show the fasteners for
the
ends of the trim, it does indicate the following:

BN7:  5 tapped plates, 4 - 3/4 inch long screws, and 3 - 5/8 inch long
screws

BT7:  6 tapped plates and 9 screws

I'd go check my BT7 and see what fasteners are used, but due to the ice
storm, I'm not willing to walk out to my detached garage yet.

Ron

-----Original Message-----
From: healeys-bounces+ronald-ray=sbcglobal.net@autox.team.net
[mailto:healeys-bounces+ronald-ray=sbcglobal.net@autox.team.net]On
Behalf Of Warthodson@aol.com
Sent: Tuesday, December 11, 2007 8:37 AM
To: linwoodrose@mac.com; healeys@autox.team.net
Subject: Re: [Healeys] Aluminum cockpit moulding - BT7


Have yo checked a parts book to see what type screw was used? I would
like
to
know the answer, too. I don't have a BT7 book or I would look it up for
you.
Gary Hodson
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
**********************************************************************
This message is intended for the addressee named and may contain
privileged information or confidential information or both. If you
are not the intended recipient please delete it and notify the sender.
**********************************************************************
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys

<Prev in Thread] Current Thread [Next in Thread>