Hi Greg,
The plunger is physically located under the side cover/solenoid bracket.
There is a lot of spring pressure under this cover. Release the bolts
gradually & evenly. With the cover off, deep inside is a brass hex plug.
It may be very tight so make sure the socket fits well.
Regards,
Dave Russell
Greg Lemon wrote:
>Thanks Bob and John, just what I needed, off I go to get greasy, Greg
>
>----- Original Message -----
>From: "Bob Haskell" <rchaskell@earthlink.net>
>To: "Greg Lemon" <glemon@neb.rr.com>
>Cc: <healeys@autox.team.net>
>Sent: Saturday, October 27, 2007 10:38 AM
>Subject: Re: [Healeys] O/D Problems
>
>
>
>
>>Greg,
>>
>>It's the ball bearing / plunger / spring at the OD hydraulic pump. See
>>the picture at the start of Part 2 -
>>http://www.team.net/www/healey/tech/big_hly/od/delborder_od.html
>>
>>Have you hooked up a pressure gauge to the OD yet?
>>
>>Bob
_______________________________________________
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|