OK what is the URL that we can use to see the picture. I get a strange error
message using the one that you gave even when I input the second line.
John Sims, BN6
Aberdeen, NJ
www.healey6.com
-----Original Message-----
From: healeys-bounces+ahbn6=optonline.net@autox.team.net
[mailto:healeys-bounces+ahbn6=optonline.net@autox.team.net] On Behalf Of
linwood rose
Sent: Saturday, October 13, 2007 5:10 PM
To: Healeys
Subject: [Healeys] Smitty Conversion- Throw out bearing and arm
I am now installing the Smitty conversion to Toyota gearbox to the
engine. In the photo below please see points where I assume one would
use a thin coat of high temp grease. 1. the shaft that the throw-out
bearing rides on and 2. The pivot ball that the arm rotates against.
Am I correct about this? Thanks.
http://gallery.mac.com/linwoodrose#100049/
clutch-20grease-20points&bgcolor=black
Lin
1960 BT7 in restoration
1959 Bugeye
_______________________________________________
ahbn6@optonline.net
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
_______________________________________________
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|