Sorry to bomb the list with a MGB engine question but it is kind of a generic
engine rebuilding question.
I am ready to install my rebuild head on my 1800 MGB engine. Both the
head and block have been surfaced to insure they are flat. I have the Payen
head gasket. I have never used this type of gasket before. It has small
inset
copper rings around the water and oil holes. There is still some
depressed corrosion eroded areas around the water holes in the block with
rough
surfaces. I am concerned that the small copper rings in the gasket might
not be big enough to seal these holes. Should I use some type of gasket
sealer? And if so, which one?
Thanks for any advise.
Ron Fine
66 MGB
61 BN7
_______________________________________________
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|