Hi Alan,
I guess if you wanted to steam the plywood you could go that route, but 1/8"
plywood doesn't really need it. It will conform to the piece of wood that
has the half round foam padding attached to it. The hard part of making the
dashpad is the compound curve of that wood piece. It curves down and back to
the rear of the car as it gets closer to the doors. You could steam that
piece but I just cut it out of a large plank of wood with a saber saw. Heck
of a lot cheaper than the $240 Moss quotes for the BJ8 dash and kind of a
fun project if that's your thing. I designed LED courtesy lights into mine.
Cheers,
Greg
-----Original Message-----
Dan -
You don't want to make your own dash. You have to have properly cut
and steam-curve the plywood. It's a huge pain in the arse for
something you can buy new and fits well. I'm pretty sure the Moss
ones fit well. If not sure, try Bob at Autofarm... he has good
fitting wood.
Cheers,
Alan
_______________________________________________
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|