G'day
Please excuse my antipodean dumbness.
I like the term "smoke wrench". Is it a euphemism for a big hammer?
Hoo Roo
Patrick Quinn
Sydney, Australia
-----Original Message-----
From: healeys-bounces+patrick.quinn=det.nsw.edu.au@autox.team.net
[mailto:healeys-bounces+patrick.quinn=det.nsw.edu.au@autox.team.net] On
Behalf Of awgertoo@aol.com
Sent: Wednesday, 12 September 2007 10:02 AM
To: healeys@autox.team.net; caahc@yahoogroups.com; Orbittor@aol.com
Subject: [Healeys] Targa Newfoundland--update
Shortly after my post this afternoon we were notified that the new
halfshaft was in fact arriving at the Gander airport in about 30
minutes.? When we installed it the flange would not pull up tight to the
face of the hub and on close examination it became clear that the axle
housing itself was bent on both ends--no doubt the reason for the break.
In fact there were some wear marks on the left side axle as well where
it was rubbing against the bearing housing.
In any case we removed the axle housing from the car and brought it to a
nearby service station where--as I write--several locals are attempting
to straighten it with the judicious use of a four-post lift with a 250
Ford loaded on top of it for weight along with a smoke wrench.?
I'm anticipating that it will all go back together and that we will be
able to drive tomorrow so I am going back to the hotel to begin to work
on the day's route books.
Best--Michael Oritt
**********************************************************************
This message is intended for the addressee named and may contain
privileged information or confidential information or both. If you
are not the intended recipient please delete it and notify the sender.
**********************************************************************
_______________________________________________
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|