Hi Mitch,
When you have everything installed just check to ensure that when the clutch
is in its normal rest position you can push the slave cylinder piston back
sufficiently to produce a little play between it and the rod.
i.e. in the normal position the piston is not fully at the bottom of the
slave cylinder thus preloading the clutch release mechanism against the
release bearing.
Michael Salter
100S (1955)
3000 Mk111(1965)
100 (1953)
AHX12 (1953)
Bugeye (1961)
http://www.netbug.net/blogmichael/
-----Original Message-----
From: healeys-bounces+msalter=precisionsportscar.com@autox.team.net
[mailto:healeys-bounces+msalter=precisionsportscar.com@autox.team.net] On
Behalf Of caddi5@comcast.net
Sent: August 26, 2007 6:57 AM
To: healeys@autox.team.net
Subject: [Healeys] slave push rod
Hello list,just received new clutch master,slave cyl.,hose etc. from moss
..the new slave cylinder actuator (push rod) is about 1/4" longer than the
original. will this be a problem? any info. will be appreciated. thanks
Mitch
1959 bn4
_______________________________________________
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|