Bill,
No, they are not the same at all. The filler valance panel to shroud is a
solid black round section with a flat "tail", the tail pinching between the
panels and slotted appropriately for the screws.
The black moulding between the main fascia panel and instrument pod is the
same section as the overrider to main bumper bar. It just needs to be
slotted out on the inboard side for clearance where the weld tabs are on the
instrument pod. These inside notches are not seen when assembled.
Rich Chrysler
----- Original Message -----
From: "WILLIAM B LAWRENCE" <ynotink@msn.com>
To: <craigsuerice@iquest.net>; <mlempert@bellsouth.net>
Cc: <healeys@autox.team.net>
Sent: Saturday, June 16, 2007 11:48 PM
Subject: Re: BN1 Split Dash Question
>I re-used the old piece too, but I think the rubber strip is the same
>profile as the one that goes between the lower front shroud and the the
>filler panel behind the bumper.
>
> Bill Lawrence
>
>
>> >
>> > Date: Mon, 11 Jun 2007 14:08:49 -0500
>> > From: "Craig and Sue Rice" <craigsuerice@iquest.net>
>> > Subject: Re: BN1 Split Dash Question
>> >
>> > John,
>> > An extruded rubber piece was located between the facia and instrument
>>panel
>> > on BN1's up to Body Number 1854 (Car/Chassis Number not known). My BN1,
>>with
>> > all of it's original sheet metal, purchased new by my Father, has this
>> > rubber piece. Body Number 1457, Car/Chassis Number BN1L 150907 was
>> > built
>>on
>> > 14 January 1954. I'm using my original rubber piece. Don't know of any
>> > sources except you might find a similar shape in a extruded rubber
>>catalog.
>> > Has anyone done this???????
>> > Craig Rice
>> > - ----- Original Message -----
>> > From: "John Rued" <rudedoggg@earthlink.net>
>> > To: "List Healey" <healeys@autox.team.net>
>> > Sent: Sunday, June 10, 2007 9:47 AM
>> > Subject: BN1 Split Dash Question
>> >
>> >
>> > > Is there a rubber gasket-type piece that fits between the fascia and
>>the
>> > > dash? is there a source for that piece?
>> > >
>> > > Thank you,
>> > >
>> > > John Rued
|