Hi John,
I don't know if your car is the same as mine. My BN2 has a cable clip
(P clip) or two that fasten under transmission side cover screws for
the OD harness. It doesn't come anywhere near the U joint.
The wiring going to the rear of the car is similarly clipped just
inboard of the frame longitudinal member. This wiring is not near the
U joint either.
Dave Russell
John Sims wrote:
> I pulled the tranny tunnel to do some "things" and noticed that the
> wiring harness is right up next to the drive shaft and appears
> that it is close enough to rub against the forward u joint. Is this
> correct? How can I be sure that when I put the tunnel back on that
> the harness will not rub against the u joint fraying the wires and
> causing real problems down the road?
>
> John Sims, BN6 Aberdeen, NJ
>
> www.healey6.com
|