Greg,
I used double back tape to secure the foil/bubble/foil heat barrier
(Reflectic Inc. BA820) I used.
Be sure to insulation sides and bottom of the ash tray recess.
Ron Ray
-----Original Message-----
From: owner-healeys@Autox.Team.Net
[mailto:owner-healeys@Autox.Team.Net]On Behalf Of Greg Lemon
Sent: Friday, April 27, 2007 9:53 PM
To: healeys@autox.team.net
Subject: Adhesive for heat shield
While the engine is out of my car I have decided to make a few other
improvements, one of which is to insulate the cockpit better. Since the
carpet is very much glued to the tunnel I would like to add the aluminum
foil
faced insulation to the inside or underside of the trany tunnel.
I started to use some Kryon general purpose spray on adhesive, but I don't
think it will hold up to the heat, oil, etc. very well, any thoughts on a
good
adhesive to use, maybe something from the local big box hardware store,
preferably not too exensive as I do have a little bit of area to cover.
Greg Lemon
54 BN1
|