Bob,
On an original wired BN2 the sending unit lead passes through it's own rear
bulkhead grommet/hole located two inches to the right of fuel tank 5/16
diameter outlet pipe at top of fuel tank elevation, under the "boot main
floor covering assembly (4B 2208)" to the sending unit.
Craig Rice
BN1 & BN2
----- Original Message -----
From: "Bob Haskell" <rchaskell@earthlink.net>
To: "healeylist" <healeys@autox.team.net>
Sent: Saturday, December 30, 2006 1:10 PM
Subject: fuel gauge sending unit lead
Listers,
A question on the routing of the lead for the sending unit - does it go
through the grommet/hole in the rear bulkhead for the rear harness or does
it go
through the smaller hole just inboard of the first hole? Then, what is its
path
to the sending unit? Run along the back of the tank or along side?
Thanks,
Bob
|