Hi Lin,
Whew, I found it!
I have an old original block saved from when I had my tricarb BT7.
These blocks are exactly 1 5/8" by 1 1/4" by 15/16" thick. They are counter
bored right through the middle to take the sheet metal fixing screw. The 1
5/8" size goes across the width of the car as per this picture.
Rich Chrysler
----- Original Message -----
From: "linwood rose" <linwoodrose@mac.com>
To: "list healey" <healeys@autox.team.net>
Sent: Sunday, September 03, 2006 2:09 PM
Subject: wood block - door seal cap
> Can anyone give me the dimensions (all three) of the two little vinyl
> covered wooden blocks that fit under the aluminum door seal caps on a
> BT7? I am talking about the piece that the furlex/rubber seal secures to
> at its conclusion toward the rear of the car.
>
> Thanks very much.
>
> Lin Rose
> 1960 BT7 in restoration
> 1959 Bugeye
[demime 1.01d removed an attachment of type image/jpeg which had a name of 3000
Rdstr Detail 0014.jpg]
|