I purchased a Facet today at NAPA for a back up (BJ8) and am now considering
the best route for installation. It appears that it can easily be mounted on
the bulkhead on the drivers side under the rear seat, with the fuel line
from the tank diverted to the Facet, then out of the Facet to the inlet of the
SU., leaving the outlet of the SU intact. When the SU is working, it will draw
through the Facet, and when the Facet is working, it will pump through the
SU. Will that work, or is there a better way? If a toggle switch is used to
select one of the pumps for use, I would appreciate thoughts on the location
of the switch and wiring instructions. Thanks to all. Ed Brennan
|