Bill -
Can you tell us is this a new aftermarket cable, or is this the old cable
you just disconnected to do some work, and you don't know how it goes back?
Alan
On 8/17/06, INSIDEDIM@aol.com <INSIDEDIM@aol.com> wrote:
>
> Hi Y'all.
>
> I've pretty much been a lurker on this forum but have gleaned a lot of
> information from all of you who have gone before me and I thank you all
> for your
> valuable contributions. My problem: I'm trying to get the
> heater control
> cable connected to the heat duct assembly and the "trunnion" pin that
> will open
> and close the heat flow. It seems to me that the cable is too long as
> there
> doesn't seem to be a way to loop it so it connects without seriously
> kinking
> the cable. Am I not seeing something? I pulled out the fascia board
> again
> to get a good look and I'm still stymied. I'm ready to get out a hack
> saw and
> shorten it.
>
> Thanks in advance,
> Bill Ravin
> BJ8 phase 1
|