Mark -
Your flywheel should have been dynamically balanced, so you can mount it to
the crank in any position.
Best Regards,
Alan
'53 BN1
'53 A90
'64 BJ8
On 8/8/06, Mark and Kathy <mgtrcars@galaxyinternet.net> wrote:
>
> Any input on this question would be appreciated.
>
> Thanks, Mark
>
>
>
> >I actually thought that I would be installing the engine and gear box
> this
> > weekend but not a chance. Always something else that needs to be done
> > before
> > the big install and then that something turns into another something.
> You
> > all
> > have been there I'm sure.
> >
> > My question today is that I don't find an arrow or # 1 on the fly wheel
> as
> > the
> > manual illustrates. It was either removed when I had it resurfaced or
> it
> > never had one.
> >
> > I matched my fly wheel up as close to what I could see in the manual
> > picture
> > and of course the engine is set at #1 TDC. Any problem with this?
> > Everything fit fine but I haven't secured the lock tabs yet so any feed
> > back
> > tonight would be appreciated so I can get the clutch on and ready for
> > install.
> >
> > Thanks, Mark
|