Jack,
See below:
> All welded bolts holding the seat slide to the floor of the car were
> broken off during dismantling by the P.O. I'll have to drill them out
> and replace them with new bolts. Three questions:
The bolts have a flat, round head, not a hex head; I assume for clearance. The
head is 1/2 inch diameter and 1/16 inch tall. I milled the heads off mine to
remove the old ones.
> (1) what is the thickness of the wooden piece that goes between the
> floor and the rail
3/8 inch
> (2) what is the length of the bolt projecting from the underside of the
> rail;
The ones that go through the floor are about 0.83 inches long from beneath the
head. The threaded section is 3/4 inch. The thickness of the rail is about
0.082 inches (not threaded).
> (3) I have only one complete set of two slides, one with a handle, one
> without. In order to know whether this is for the left or the right
> seat: where should the handle be - in between the rails or on the outside?
In between the rails.
|