Walt, you stated that you "had" them rebuilt. If you paid to have
them rebuilt, first I would check with that company. They might want
the opportunity to correct the problem before you start taking them
apart and trying it yourself. Or, they might give you some direction
to take.
Brent.
--
Brent Porter
BT7, AN9, TR4
Indianapolis, IN
On 5/17/06, Walton Curl <WCURL@mail.mcg.edu> wrote:
> I have a 60 BT7, and I recently had carbs rebuilt, but I can't get the
> idle down below 1100 rpms on the rear carb, the front carb will stall
> out as I screw the throttle adjusting screw down, the rear carb,
> however, will not stall or decrease below about 1100 rpm's even with the
> screw set all the way down. The only way to balance the carbs is to set
> the front at the same idle speed. The throttle screw seems to be fine
> (no obvious defects in it), could this be from an air leak through the
> shaft or through the throttle plate? Any thoughts would be
> appreciated.
>
> Walt Curl
|