First time I heard of a buffer going on the OD plate. "Sure Bout that
Mate"?
Mark
----- Original Message -----
From: "Tracy Drummond" <bighealey@charter.net>
To: "'Jim Shope'" <healeymanjim@joimail.com>; <healeys@autox.team.net>
Sent: Monday, March 27, 2006 12:14 AM
Subject: RE: trans
> Jim,
>
> These came from 1st gear or the 3/4th gear sliding hub assembly. This is
> usually caused by the buffer stops being gone or running through gears
> with
> the tunnel off. It is caused when the selector shaft goes too far and the
> sliding hub outer allows the detent balls and springs to be liberated. At
> any rate you need to pull it apart and return them to their home being
> sure
> to put the buffer pads back in both in the OD plate and bell housing
> recess.
|