Hi Alan,
If JB Weld works correctly, the cables will be impossible to ever
remove. Set screws would be much better.
Dave Russell
Bn2
Alan Schultz wrote:
> Jorge, That is the original intent and the springs would be strong
> enough to pull the chokes off. However, I have seen the blocks
> drilled and tapped and screws used to hold the cables in place so
> pushing the choke cable in does push on the cables going to the
> carbs. I would not hammer, solder or weld them in place. I wonder if
> JB Weld would hold them in place?
>
> Alan Schultz 67 BJ8
|