Just as a start I think the wires you are showing are the ones that attach
to the relay box. That is the only place that combination of colors will
occur, they have the correct ends and they look the right length.
There are three harness legs that run away from the relay. One drops down
from the area of the relay to the chassis and runs to the horns (er
hooters), the stop lamp switch and the rear turn signals. You should see
green, green/purple, brown/green, white/brown and white/purple.
One branch runs back through the harness where it emerges on the right inner
fender and feeds the right headlamp and side/turn signal lamp. You should
see blue/white, blue/red, red and green/white.
One branch runs forward on the left inner fender and feeds the left headlamp
and side/tail lamp. You should see blue/white, blue/red, red and green/red.
Good luck.
Bill Lawrence
Bill Lawrence
|