Phil,
VHT makes some good stuff, and it is the only paint that I have used that
works/lasts on cast iron. No paint will survive on tubular headers.
Cheers,
Chris
BJ8
----- Original Message -----
From: "Philip S. Anson" <pansonm1@maine.rr.com>
To: <healeys@autox.team.net>
Sent: Sunday, August 14, 2005 3:07 PM
Subject: high-temperature paint for exhaust
> Folks - finally getting down to the last bits of reassembly of our 1960
> BT7;
> exhaust was new in mid-70's and has had minimal use since - solid, sounds
> great, etc. However, it is rusty throughout. Headers are braised to the
> pipes; manifolds have been done by Jet-Hot. Is there a source for a high
> temperature aerosol paint that I could apply to the entire system before
> putting it back on the vehicle?
>
>
>
> Thanks in advance; I'll look forward to everyone's input.
>
>
>
> Phil Anson
>
> Portland, ME
|