"" <ab7vf@zworg.com> wrote:
>
>
>
> Alan F Cross <alanx@proaxis.demon.co.uk> wrote:
> >
> > Mine I have to back off nearly a quarter of a turn to get the split pin
> > in. Suppose I could try and wrench it on a bit tighter, to get to the
> > next slot.
> >
> >
>
> to all:
> What I've done in the past when this has been encountered is file a
> bit off the 'backside'
> of the nut .. re tighten and check alignment with the cotter/split-pin
> ... repeat until the
> cotter pin lines up at the proper torque ... Works great on 'Model T'
> rods ...
> Jim
|