Patton,
Now I see what you mean (in your pics) about the 2 extra holes. Looks like
they have the same spacing as the 2 larger turn button holes. This would be
alternate lations for the turn button. Ignore them.
----- Original Message -----
> I am still not sure what all five of the holes on top of the cowl are.
> I think that the most forward is the trim screw. The two larger ones
> seem to be the ones for the tonneau buckle. That leaves two tiny ones
> unaccounted for.
>
> I know that I going to have to remove the windshiled post then install
> the dashpad before the dash. I am concerned about accuratly locating
> the places I need to drill holes in the dash pad wood for the above
> holes (especially the smaller ones). This links to pictures of both
> sides of my cowl as well as the underside of my dashpad.
> http://img78.exs.cx/gal.php?g=RHCowlTop.jpg
Temporarily position the dash pad then come up from beneath with a sharp
scriber or small awl and mark the position of the screw hole, then drill
down through carfully. This should be fixed in place with a cup washer same
as door panel screws, etc. and a #6 phillips countersunk self tapping screw.
Don't forget the contrasting piping that will go along this edge see the
pics I already sent you. Even if your aftermarket black interior kit doesn't
have contrasting piping, get some black piping and position and glue it
along this edge to finish the end of the panel.
Rich Chrysler
|
