Thanks Mike.
I got these from LBCar which are Moss hook mount no. 222-209. I am concerned
about the top. Is the wrap/bundle the lenght of your top? I was thinking of
bolting the belt to the top of the arch but i did not consider the top
getting in the way when it is down. I have no otop as of yet and I have
never seen a BN7 with the top in stowage.
Thank!
Scott
>From: mike brooks <hypercubic@yahoo.co.uk>
>Reply-To: mike brooks <hypercubic@yahoo.co.uk>
>To: ahpowered@hotmail.com, healeys@autox.team.net
>Subject: Re: BN7 Seat belt installation
>Date: Mon, 28 Mar 2005 16:54:14 +0100 (BST)
>
>Hi Scott,
>
>I recently installed three point inertia reels in my BN2. I fixed the
>shoulder mount to the side of the inner wheel wells fairly low down, to
>minimize the interference of the folded down top with the inertia reels. I
>got the belts from Norman Nock who was most helpful in providing mounting
>advice. You didn't say if your belts are inertia reel. If they are, you
>need the type that can be adjusted so the internal ratchet arrangement is
>verticle or horizontal, even with the reel mounted at an angle. Again with
>advice from Norman, I got a "wrap" of material made that fits around the
>folded down top. This pulls the top into a tight bundle and allows the
>inertia reels to run freely underneath.
>
>Mike
>
>Date: Sun, 27 Mar 2005 14:22:25 -0600
>From: "scott willis" <ahpowered@hotmail.com>
>Subject: BN7 Seatbelt Installation?
>
>Hi all,
>
>I have a 3 point hook system I am putting in. I found where I plan to
>drill
>in the floor but I am not sure where to bolt the shoulder strap mount.
>
>Should I mount it on top of the inner wheel well? Or should I mount it
>on
>the side of the rear wheel well? Any other suggestions? I am affraid to
>damage any of the vinyl covered wood.
>
>I'm this close to safety!
>
>CHeers,
>Scott
>
_________________________________________________________________
FREE pop-up blocking with the new MSN Toolbar get it now!
http://toolbar.msn.click-url.com/go/onm00200415ave/direct/01/
|