Rich: I'm sure someone else has responded but just in case:
My tenex fastener measures 1 5/8 inches from the 'seam' at the bend of the
trim or 3 inches from the door seal at the door and 1 3/4 down from the top
of the door seal.
The snaps for the boot cover are about 3/4 inch down and 2 inches in from
the trim.
The "3000" on the blanking plate is about 3 inches long and is in 'italics'
- that is, about a 30 degree slant forward.
(The Other) Len
Vacaville, CA
1967 3000 MKIII HBJ8L39031
> [Original Message]
> From: Rich C <richchrysler@quickclic.net>
> To: Healeys <healeys@autox.team.net>
> Date: 3/10/2005 7:29:43 PM
> Subject: BJ8 Details
>
> Hello all,
> I'm needing a couple of specific dimensions for the placing of fasteners
on a
> '65 Phase 2 BJ8.
> On the leading edge of the rear quarter trim panels, just behind the door
> openings and just down from where the rear bit of door seal ends there are
> tenax studs for fastening the strap on the front of the top boot cover
when
> fitted.
> Can somebody with preferably original panels give me some dimensions for
the
> exact locations of these?
> Also on the forward edge of the rear panel that separates the stowed top
from
> the rear seat area, there are male bases for the domed snaps on the top
boot.
> Can somebody provide the dimensions for locating these? I know one is on
> centre, but what about the left and right one?
> Last item; a radio blanking plate is being fitted to the console. The 3000
> flash that goes on this blanking plate, is it on an angle or do the 3000
> numerals run parallel to the horizontal edges of the plate? Any dimensions
> would again be helpful.
> Thanks very much in advance.
>
> Rich Chrysler
|