-----Original Message-----
<<<< 1. What is the proper size of the wrench/spanner to fit the
crankshaft nut?
(66 BJ8)>>>>
That would be a 1 11/16 inch wrench
<<<< 2. Do I have to jack the motor up to remove the crank nut and pull
the
pulley/damper to perform this work or is there enough room without
raising?
(or how much raising is needed?)>>>>>>
You will need to raise the engine slightly to remove the pulley/damper,
if using an aftermarket damper you will need to raise it a lot. Have
plenty of beer standing by for this one.
Don
57' BN4 (Been there and done that)
|