Thomas -
As long as you replace the paper gaskets with pre-made
paper gaskets (don't make these yourself), and replace
the o-rings... and keep everything clean... you
shouldn't get any leaking. I would not use any
sealant or anything like that... it may not hold up
over time.
What you should do is consider replacing the hub oil
seal, that's where alot of the leaks come from ...
it's a little bit of a hassle, but a cheap repair well
worth it.
Cheers,
Alan
'53 BN1 '64 BJ8
--- Thomas Mulligan <tpmul@worldnet.att.net> wrote:
> I am in the process of swapping the rear gears on my
> BJ8 (3.90) for the
> Lempert set (3.54) that I bought a few years ago.
> I was wondering if anyone uses any coating or
> additional sealant when
> reinstalling the thin paper axle-shaft-to-hub
> gaskets. The old ones came off
> quite easily and I never had any problems with
> leaks. The o-rings will also
> be replaced.
> Thanks
> Tom
|