Listers,
While working through my engine rebuild (3rd house mortgage) it dawned on me
that while I was at it I may as well replace the head nuts since the bolts are
already new. Are head nuts just grade 8 fine thread nuts available from
most home stores or are these specific to engine heads only?
Any suggestions on heating a 2.5 stall garage other than tapping into my house
gas. My kerosene torpedo unit (50,000btu) is too noisy/smelly and the
small electrics cost too much to run.
Is propane a viable heat source?
Any other kerosene type units that don't smell and make so much noise?
Its a bit hard to test these things in the stores.
Thanks in advance, Mark
|