That makes a lot of sense, thanks for the tip!
Patton
-----Original Message-----
From: owner-healeys@Autox.Team.Net [mailto:owner-healeys@Autox.Team.Net] On
Behalf Of Paul Negus
Sent: Wednesday, October 27, 2004 9:56 AM
To: healeys@Autox.Team.Net
Subject: 100-Six Metal Heat Shield Question
Patton
I stopped my H4 carbs losing gasoline from the float chambers when the
engine had been switched off by doing this. It stops heat soaking up below
the chambers, especially on the rear carb.
Regards
Paul
>Date: Wed, 20 Oct 2004 11:14:29 -0500
>From: "Patton Dickson" <kpdii@earthlink.net>
>Subject: 100-Six Metal Heat Shield Question
>I believe that the later carbs heat shields car covered while the
100-Six shield is just sheet metal. Is their any benefit of >covering the
inside of the heat shield with one of these space age coverings to help
deflect the heat?
>Thanks
>Patton
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|