Hello Robert
I have a Allison xr700 on my 100/6, no problems in 15 years
Purple wire-Ground/chassis
Red wire-Coil positive +
Black wire-Coil negative -
+12 volts from Ignition switch to Ceramic Balast resistor
Othe side of Balast resistor to Coil positive +
Scott Johnstone
----- Original Message -----
From: "Robert - 65BJ8" <rnbmail@yahoo.com>
To: "Healeys List" <healeys@autox.team.net>
Sent: Tuesday, October 26, 2004 9:40 AM
Subject: 65BJ8 solid state ignition, and, carb heat shield materials?
> Hello List,
>
> A BJ8 restoration is making slow but solid progress.
> Help would be appreciated on a couple of items:
>
> 1. My car has an Allison Automotive [Covina, CA]
> solid state ignition module, [about 2x3 inches] and
> the associated optical trigger in the distributor.
> Does anyone have experience with this device - good or
> bad, and does anyone have a circuit diagram that came
> with the device. AS far as I remember before the tear
> down it was working, but I now need to decide on its
> future?
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|