Each is fastened to the iner wheel arch with 4 phillips truss head self
tapping sheet metal screws. Then there is a bottom strap held to the splash
shield with a 10-32 posi drive pan head machine screw. The other end of the
strap fastens to the lower outer bolt in common with the grille assembly and
the radiator duct assembly. Quite a sandwiched affair!
Rich Chrysler
----- Original Message -----
From: "Ron Fine Esq." <ronfineesq@earthlink.net>
To: <Healeys@Autox.Team.Net>
Sent: Saturday, October 02, 2004 3:22 AM
Subject: Attachment of splash shield
> The splash shields on the inside of the front wheel wells on my BN7 were
> missing. I purchased two new ones which are predrilled with matching
> holes
> but I don't know what was used to attach them to the inner fender. Pop
> rivets, screws, nuts and bolts, ??? Any help is always appreciated.
> Ron Fine
Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8
|