Barry -
Take the bolts off and put a thin coat of Permatex
copper silicon sealant on each side of the Cu washer.
That should seal it. Also, if you tightened it
loosely, you can tighten it to about 15 to 20 ft-lbs
of torque - the Cu washers need a little pressure on
them to seal.
Cheers,
'53 BN1 '64 BJ8
--- jbpate@attglobal.net wrote:
> Looks like I have an oil leak around the bolt on the
> middle and rear
> lifter access panels. The Cu washers are there but
> original. Other than
> new washers what other methods might be used to stop
> the leak. . This
> is a complete rebuild with about 100 miles on it.
> Barry Pate 1967 BJ8
|