Bill,
Thanks for the update. I think I remember the problem but had no ideas.
Don't know a thing about adjusting "the" switch. When you find out, let
us know.
Good luck on the project & have fun at Glenwood.
Dave Russell
BN2 without "the" switch
Bill Lawrence wrote:
> Some may recall about a year and a half ago I was asking if anyone knew
> of a problem that could cause a vibration on the road when operating
> only in overdrive. Well in preparation for another road trip in June,
> yesterday I spent a pleasant afternoon pulling the tranny out of the BN1
> to see if I could get to the bottom of the problem.
> I have been running with my centrifugal switch jumped out for the last
> two years and have just recently decided to check its operation. It
> seems to work, but is nowhere near its designed set points coming in at
> about 20 MPH and dropping out at about 5 MPH. Can anyone tell me how
> these are supposed to be adjusted? There are two screws on the switch,
> Off to Glenwood June 11-13.
>
> Bill Lawrence
|