seals, not shields. if you are trying to install anything other than the ones
with a Healey Motor Works, santa barbara, ca overprint on them, you are wasting
your time. there is a good pic on page 109 ( center pic ) in the
anderson/moment restoration guide. bill bolton ( tricarb@aol.com or
billb@healey.org ) was the only source for this item originally manufactured by
don mollet in the late 70's.
visualize a gutter along the end of the dash panel and over the inner curvature
of the fender. note bottom pic on page 108 also.
James Lea wrote:
>
> I have spent the day working on one of the most frustrating jobs I have ever
> done on the BT7, trying to install the rubber scuttle shields. I have them in
> with the proper rivets and washers and now need to know more about the way the
> end fold back under the scuttle cover. The directions are not very clear (at
> least to me) and I can't find a good picture in any of the restoration
> manuals. Any advice or pictures would be GREATLY appreciated. Cheers, JL
>
> James Lea
> Rockport Maine
> 1962 BT7 II
|