JL,
My seat backs fit mostly inside of the bottom pans. There is a rubber
bumper on the inside edge of the pan, under the vinyl, that catches &
cushions the bottom of the seat back & prevents full contact between the
two parts. I don't know if this is standard or something that was added.
In any case, it works very well to prevent cutting the seat back. Why
not ask Heritage about it?
Dave Russell
BN2
James Lea wrote:
> Last year I sent my rebuilt seat frames back to Heritage and had them install
> the new leather covers. They have been in the car one season and when I took
> them out to pull the trans I found that the material on both backs was cut to
> the metal along the bottom edge where the back meets the bottom frame. Has
> anyone else had this problem and if so, what do you advise for a cure Right
> now the cuts are only two inches long but I don't want them to get worse.
> Thanks in advance, Cheers, JL
>
> James Lea
> Rockport Maine
> 1962 BT7 II
|