Mordy Dunst can make you figure 8 gaskets of ANY thickness.
*Never be beaten by equipment.*
On Sun, Jul 23, 2017 at 12:01 PM, timmmurphh--- via Fot <fot at autox.team.net>
wrote:
> I?m having a block decked and the liner seats recut to get the proper
> stick out of 0.003 to 0.005. The figure 8 gaskets I?ve gotten in the past,
> mostly steel, were 0.015 to 0.016 thick. Even an old set of copper figure
> 8?s measure 0.016. The latest copper figure 8?s from British Parts North
> West measure 0.020.
>
>
>
> The 0.015 to 0.016 Figure 8?s gave the proper stick out with the old
> block. My concern is that if I have the liner seats cut for the 0.020
> gaskets, that in the future I may not be able to get these. I?m also a bit
> confused as to how in the past the 0.015 to 0.016 apparently worked, but
> now are people using the 0.020? And how are they getting the stick out
> within specification?
>
>
>
> Thanks for any input on this. I?m taking the block over to the machine
> shop, about 60 miles away, tomorrow, but I don?t necessarily have to decide
> on the liner seats until they actually get it set up on the boring machine.
>
>
>
> Tim
>
>
>
> P.S. I talked to Steve Yott and he said the figure 8 gaskets that come in
> the gasket sets are measuring at 0.020.
>
> _______________________________________________
> fot at autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/
> options/fot/kaskastner at gmail.com
>
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/fot/attachments/20170723/2222a113/attachment.html>
|