Patrick, Kees and Harold, thank you for your helpful comments.
Cheers
Mark
Ardmore
NZ
_____
From: Mark Donaldson [mailto:ardmorebusiness at xtra.co.nz]
Sent: Sunday, 11 June 2017 2:22 p.m.
To: healeys at autox.team.net
Subject: [Healeys] Generator pulley dimensions
Listers,
Until now I'd never noticed the small differences in generator pulley
diameters.
What is the diameter of the pulley fitted to a Mk II tri-carb - part number
AEC 910 ?
The one presently fitted to mine is 100mm. It does not have a part number
on it.
I have a 100/6 pulley with part number AEC 291 sitting on my shelf.
It shows the part number on the casting and has a diameter of 110 mm. (see
photo attached.)
As a matter of interest - could the 100/6 pulley be used on a later model
without adverse effect - bearing in mind the generator speed would be only
marginally reduced.
Mark
Ardmore
NZ
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170613/a545cbd0/attachment.html>
|