Hello
It?s a C26W or Wolseley six-cylinder engine with a standard 3/8 in wide belt.
Hoo Roo
Patrick
From: John Rowe [mailto:john at jtkarowe.com.au]
Sent: Tuesday, 28 February 2017 7:24 PM
To: 'Peter & Veronica'; 'Patrick & Caroline Quinn'; healeys at autox.team.net
Subject: RE: [Healeys] Water Pump Pulley Circumference
Hi Patrick
I don?t have a BN3 one to measure, but a 29D ex Mk1 circumference measures
295mm approx (approx 11.5?) at the bottom.
Do you have the later narrow belt or the wider one off the 4 cylinder cars?
Regards
John Rowe Qld.
From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Peter &
Veronica
Sent: Tuesday, 28 February 2017 5:17 PM
To: Patrick & Caroline Quinn; healeys at autox.team.net
Subject: Re: [Healeys] Water Pump Pulley Circumference
....what do you mean by 'within the groove' Patrick? Pulley diameter? If so do
you mean cm rather than inches?
Cheers
Peter
From: Patrick & Caroline Quinn
Sent: Tuesday, February 28, 2017 4:32 PM
To: healeys at autox.team.net
Subject: [Healeys] Water Pump Pulley Circumference
Greetings
Today the new six-cylinder water pump for the BN3 arrived from AH Spares.
I have noticed that the ?within-the-groove? circumference of the new pump is 11
? inches, while the ?within-the-groove? circumference of the old (original)
pump is 14 inches.
Apart from the pump running a little faster I can?t see that it will make for
any other differences.
Does anyone have a pump they can conveniently measure please? Plus any comments
would be appreciated.
Many thanks
Patrick Quinn
Blue Mountains, Australia
_____
_______________________________________________
Archive: http://www.team.net/archive
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170228/50e95b79/attachment.html>
|